Problem:
Downloaded Xentry passthru version for the Openport 2.0 interface (Openshell version does not run) or other passthru device (vxdiag vcx se benz etc).
Once installed, the capacity is quite large. Download capacity is 19GB
Has some problems during installation:
When the message QUI service pops up
1) Is message QUI http in administrator settings? After checking that, you can install it.
2) After installation, run config assist and enter starter key
If it doesn’t work, turn off the wifi.
You can do this by downloading the keygen.
3) If you run Xentry, you will probably get 2221-45 No access authorization error.
You can fix the error 2221-45 by fix file.
Here is the solution to Xentry passthru error 2221-45 and other errors.
Download these files
including:
- ewa keygen
- DAS license 0 day error fix for xdos and passthru
- IgnitionEnabler
- Openport2 setup
- Xentry 2221-45- error fix 06.2020
This is an error when installing for the first time.
If you see that your login is valid, delete it with that file.
XentryPassThroughService.xml in two files in notepad.
Solved by deleting and saving the second file from the bottom.
The path to the first recycle bin file you see is… Xentry Subpoldo Fusco? If you go there, delete that file.
If you get to this point, you can proceed roughly.
And before that, the OpenPort 2.0 drive must be installed, of course.
If you exceed das, the effective date will be 0 days. That too.
If the ignition doesn’t turn on and off again.
Ignite from Google (get the Ignition file and run it). It is ok.
If need xentry openshell version, check here
https://www.obdii365.com/wholesale/mb-star-sd-c4-dell-win10-500g-hdd.html
